USB Zone Controller (BBSP-ZC/U)

USB Zone Controller (BBSP-ZC/U)

The Enistic USB Zone Controller acts as master interface between the Enistic Energy Manager software on your PC and the Smart Sockets, Sensors and PCs running the Powerdown software in your system. With a simple plug and play fitting this controller is ideal for simple installations and / or trials and energy audits.

Because the Enistic range uses a meshing system, every module talks to every other module in order to maximise range and reliability. This means that in any office or home environment, only one USB Zone Controller is required for full coverage so long as every module is within 30m of any other module. If the Zone Controller cannot directly pass messages to any module on the network, the other modules in the range will "pass on" the message to ensure 100% operation.

Specifications

  • USB bus powered.
  • Supports Low power Modes
  • USB 2.0 Full Speed Device, backwards compatible to USB1.1 hosts
  • Form factor: USB Stick L80mm x W26mm x H8.5mm
  • Operating Temperature range -400C - +850C.

Software

  • Drivers are pre-installed for the USB controller

Technical

  • 2.4GHz ISM Band digital direct sequence spread spectrum transceiver
  • Hardware acceleration for IEEE802.15.4 operations
  • Hardware supported encryption (AES-128)
  • Pre-programmed as a ZigBee coordinator and router
  • Ideal for use as a commissioning tool when setting up networks.

User Reviews...

No User Reviews Yet

Be the first to Write a Review